[omniORB] Problem building IDL file

[Renzo Tomaselli]

Hi all,
        about the issue of OmniORB on MSVC 5.0/6.0 (on NT): I'm using
OmniORB 2.8 original binaries (just as downloaded) since more than one year.
First I did it under MSVC 5.0, then 6.0 SP3 was installed. No problem
whatsoever, no need to recompile OmniORB from sources for 6.0. Off course
the MSVC updating procedure left around many 5.0 dlls.
Just two additional cents |:-),
                                             Renzo Tomaselli
---------------------------------------------------------------------------
TecnoTP s.n.c. Special Information System Design
Maso Pelauchi I38050 Ronchi Valsugana,  Trento TN  ITALY
Tel. +39 0461 773164      Fax. +39 0461 771514
e-mail: renzo.tomaselli@tecnotp.it
---------------------------------------------------------------------------

-----Original Message-----
From: Kiran Shettigar <kiranjs@vsnl.com>
To: omniord@uk.research.att.com <omniord@uk.research.att.com>;
omniorb-list@uk.research.att.com <omniorb-list@uk.research.att.com>
Date: venerdl 23 giugno 2000 06:09
Subject: Re: [omniORB] Problem building IDL file


>Hi all,
>
>    It's not working.Now i am using msvcp50.dll but the problem still
>persists
>"Spawnvp of CL failure".Even VCVARS32.bat is not helping.
>When running  vcvars32.bat  it says following
> "Setting the environment variables for VC++ tools . Out of environment
>scope. Out of environment scope. Out of environment scope."
>
>A solution at the earliest is much appreciated.
>
>Thanx
>kiran