[omniORB] endpoint

[Allen Irwin]

I believe the problem is that your port 1060 is not available.

-----Original Message-----
From: glblock at rockwellcollins.com [mailto:glblock at rockwellcollins.com]
Sent: Wednesday, 31 March 2004 1:25 AM
To: omniorb-list at omniorb-support.com
Subject: Re: [omniORB] endpoint






Sorry; the error from the giop:tcp:hostp:1060 is



omniORB: Unable to create pipe for SocketCollection.
omniORB: Explicit bind to host hostp.
omniORB: Bind to address 10.54.1.10.
omniORB: Error: Unable to create an endpoint of this description:
giop:tcp:niu:1
060
omniORB: throw INITIALIZE from objectAdapter.cc:245
(NO,INITIALIZE_TransportErro
r)
0xfc2df90 (JA2G-0): Unhandled C++ exception resulted in call to terminate


Thanks
Gary



 

                      <glblock at rockwellcollins.com>

                      Sent by:                             To:
omniorb-list at omniorb-support.com

                      omniorb-list-bounces at omniorb-        cc:

                      support.com                          Subject:
[omniORB] endpoint

 

 

                      03/30/2004 11:06 AM

 

 












Running vxWorks on a 440 powerpc


endpoint= giop:tcp::        <- works fine

endpoint = giop:tcp::1060  <- works fine

endpoint = giop:tcp:hostp:1060  <- fails see below
endpoint = giop:tcp:10.54.1.10:1060  <- fails see below



omniORB:   traceLevel = 25
omniORB:   traceThreadId = 0
omniORB:   unixTransportDirectory = /tmp/omni-%u
omniORB:   unixTransportPermission =  777
omniORB:   useTypeCodeIndirections = 1
omniORB:   verifyObjectExistsAndType = 1
omniORB: Initialising incoming endpoints.
omniORB: Unable to create pipe for SocketCollection.
omniORB: Bind to address 0.0.0.0.
omniORB: No list of interface addresses; fall back to system hostname.
omniORB: My hostname is hostp.
omniORB: Starting serving incoming endpoints.
theCORBA
CF_DeviceGroup
omniORB: AsyncICF_ServiceGroup
nvokCF_ProcessGroup
er: CF_IDGroup
thread idProfileDVM
 = 1 has started. Total threads = 1
omniORB: giopRendezvouser task execute for giop:tcp:10.54.1.10:1060
hostShow displays
                                                allias
hostp       10.54.1.10          hostp0
hostp1      1 10.54.1.12

The card has 2 eth ports show above.  I want to be able to configure either
port for the endpoint.

other cards can ping via hostname or ip addresses.
OmniORB just seems to not want a host name value in the endpoint and will
then take the localhost ( hostp ) and run anyway?

Any help out there ?

Gary


_______________________________________________
omniORB-list mailing list
omniORB-list at omniorb-support.com
http://www.omniorb-support.com/mailman/listinfo/omniorb-list




_______________________________________________
omniORB-list mailing list
omniORB-list at omniorb-support.com
http://www.omniorb-support.com/mailman/listinfo/omniorb-list