[omniORB] weak data transfer rate on not powerful embedded sy stem

[Serguei Kolos]

May be you should use a profiler to find out where the time is spent by 
your applications.
I can tell you that with my omniORB4 based C++ applications I have 
50mbps short
messages exchange rate over 100mb Ethernet. Slow processor might be also 
a bottlenek.

Cheers,
Sergei

Jan Olderdissen wrote:

>Sending large chunks of opaque binary arguments usually helps. That way the
>CPU spends less time per transmitted byte marshalling data.
>
>Jan
>
>-----Original Message-----
>From: omniorb-list-bounces at omniorb-support.com
>[mailto:omniorb-list-bounces at omniorb-support.com] On Behalf Of Thierry
>Descombes
>Sent: Sunday, October 10, 2004 1:18 AM
>To: omniorb-list at omniorb-support.com
>Subject: [omniORB] weak data transfer rate on not powerful embedded system
>
>Hi,
>We are using omniORB 4 on an Axis MCM Etrax chip (embedded system 
>with Linux 2.4).
>We recently notice that the transfer rate is really weak ! (near 3Mbps 
>on 
>an interface 100Mbps full duplex !)
>Is there something to do to increase it ? (compiling options or command 
>line options ?)
>All suggestions will be welcomed!
>Thanks in advance
>Cheers,
>Thierry DESCOMBES
>
>
>_______________________________________________
>omniORB-list mailing list
>omniORB-list at omniorb-support.com
>http://www.omniorb-support.com/mailman/listinfo/omniorb-list
>
>_______________________________________________
>omniORB-list mailing list
>omniORB-list at omniorb-support.com
>http://www.omniorb-support.com/mailman/listinfo/omniorb-list
>  
>